Clean water is a basic requirement for drinking, food and beverage production, boilers, cooling towers, textile plants, hotels and remote camps. Where the only water available is brackish, saline or hard, a reverse osmosis (RO) plant is one of the most widely used ways to purify it. This guide explains how an RO system works and what goes into a properly designed plant.
How reverse osmosis works
Raw water is pushed under pressure through semi-permeable membranes. Water passes through; most dissolved salts and many other impurities do not. The result is two streams: clean water, called permeate, and a more concentrated stream, called reject or brine, that has to be disposed of correctly. The higher the salt content of the feed, the higher the pressure required, which is why seawater plants are built differently from brackish water plants.
Start with the water analysis
No honest design can start without a full analysis of the feed water: total dissolved solids, hardness, silica, iron and manganese, turbidity, chlorine, organic matter, temperature and the water source. The plant capacity, the number of membranes and the pre-treatment are all chosen from this report, together with how much clean water you need and what quality it must have.
The main parts of an RO plant
- Intake and feed tank where raw water is stored and balanced.
- Pre-treatment: multimedia filters to remove suspended solids, activated carbon to remove chlorine and organics, softening or antiscalant dosing to control scale, and cartridge filters as a final guard for the membranes.
- High-pressure pump which raises the feed to the pressure the membranes need. Seawater plants may add an energy recovery device.
- Membrane skid with pressure vessels and spiral-wound membrane elements, commonly the 8040 size in industrial plants.
- Post-treatment such as pH adjustment, remineralisation or disinfection, depending on the use of the water.
- Control panel and instruments for pressure, flow, conductivity and alarms, with an automatic flush and a clean-in-place connection.
Brackish water RO and seawater RO
Brackish water plants treat borewell and surface water with moderate salt levels at lower pressure and with lower running cost. Seawater RO plants desalinate sea water, need higher pressure, corrosion-resistant materials and careful intake design, and are used for coastal industry, islands, ships and camps. Containerised and skid-mounted plants make it faster to deliver and install in remote places.
Spare parts and consumables to plan for
An RO plant is a long-term asset only if it is kept supplied. Parts that wear or need regular replacement include:
- RO membrane elements, replaced when salt rejection or flow falls.
- Cartridge filter elements, changed on pressure drop.
- High-pressure pump parts and seals.
- Antiscalant and cleaning chemicals, dosing pumps and instruments.
- Multimedia and carbon filter media, replaced over time.
Keeping a small stock of critical spares avoids long shutdowns. We can supply membranes, pumps and other large spare parts for existing plants, including plants we did not build, if you send us the model and the nameplate data.
Operating tips that save money
- Log the pressure, flow and conductivity every day. A slow trend is the earliest warning of fouling.
- Clean membranes on schedule rather than waiting for a large drop in output.
- Never let membranes dry out. Use a preservation solution during long shutdowns.
- Protect the membranes from chlorine and from high temperature.
RO plant supply, design and installation in any location
We design, supply and install RO plants and can source spare parts for plants in different countries. Send us your water analysis, daily water demand, required quality and site location, and we will propose a plant, with scope, capacity and delivery quoted to your requirement.
See our RO plants and spare parts or contact us for a quotation.




Comments
No comments yet. Be the first to share your thoughts.